Filter
Top Products
30
h. Gently flare the braid with your fingers (see
Figure 57).
i. Insert the end of the cable into the connector
body until the dielectric is firmly seated
inside the connector (see Figure 58). Be sure
all braid wires remain on the outside of the
connector.
j. Trim any excess braid (see Figure 59), if
necessary. The braid should assemble flush to
within 1/16" (1.6 mm) of the connector
shoulder.
k. Slide the ferrule over the braid until it is flush
against the connector shoulder (see
Figure 60).
Figure 57: Flaring the Braid
Figure 58: Pushing On the Connector
Figure 59: Trimming the Braid
Figure 60: Sliding the Ferrule Over the Braid
Continued Terminating LMR-400-75 Cable
B