Filter
Top Products
Intel Desktop Board DX48BT2 Product Guide
56
1. Observe the precautions in "Before You Begin" on page 27.
2. Connect the 12 V processor core voltage power supply cable to the 2 x 4 pin
connector. Use the 2 x 2 to 2 x 4 adapter if need.
NOTE
Do not use the included 2 x 2 to 2 x 4 adapter when using an Intel
®
Pentium
®
processor Extreme Edition or other Intel processor that is not running at its
default settings. Doing so may result in damage to the Desktop Board.
3. Connect the 1 x 4 power supply cable to the 1 x 4 connector.
4. Connect the main power supply cable to the 2 x 12 pin connector.
Setting the BIOS Configuration Jumper
NOTE
Always turn off the power and unplug the power cord from the computer before
moving the jumper. Moving the jumper with the power on may result in unreliable
computer operation.
Figure 31 shows the location of the Desktop Board’s BIOS confi
guratio
n jumper block.
Figure 31. Location of the BIOS Configuration Jumper Block
The three-pin BIOS jumper block enables all board configurations to be done in the
BIOS Setup program. Table 14 shows the jumper settings for the B
IOS Setup
program modes.