Filter
Top Products
Intel Desktop Board DX48BT2 Product Guide
14
Main Memory
NOTE
To be fully compliant with all applicable Intel
®
SDRAM memory specifications, the
board should be populated with DIMMs that support the Serial Presence Detect (SPD)
data structure. If your memory modules do not support SPD, you will see a
notification to this effect on the screen at power up. The BIOS will attempt to
configure the memory controller for normal operation.
The Desktop Board supports the dual or single channel memory configurations defined
below:
• Four 240-pin Double Data Rate 3 (DDR3) SDRAM Dual Inline Memory Module
(DIMM) connectors with gold-plated contacts.
• 1600/1333/1066/800 MHz DDR3 SDRAM interface
• Unbuffered, non-registered single or double-sided DIMMs
• Non-ECC DDR3 memory
• Serial Presence Detect (SPD) memory only
• Up to 4.0 GB utilizing 512 Mb or 1 Gb technology
• Up to 8.0 GB utilizing 1 Gb technology
NOTE
For 1600 MHz memory, only two DIMMs are supported for a maximum of 4 GB utilizing
1 Gb memory technology. DIMMs should be configured as a matched pair equal in
speed and size in DIMM 0 and DIMM 1 of channel B.
Related Links:
Go to the following links or pages for more information about:
• SDRAM specifications, http://www.intel.com/technology/memory/
• Installing memory, page 37 in Chapter 2
• Tested memory, http://www.cmtlabs.com/mbsearch.asp