Filter
Top Products
8 - 7
Setting Up For Communications with the Mobile IntelliBase/Mobile Base
The Mobile IntelliBase RS-232 interface allows the Dolphin terminal to communicate to a personal computer, modem, or any
standard RS-232 device using a standard serial cable and communications software.
The IrDA 1.0 software stack is integrated into the Mobile IntelliBase/Mobile Base to allow communication between the cradle and
devices such as modems or printers that are not IrDA ready or do not communicate with a half duplex serial protocol. This allows
any full or half duplex RS-232 device to communicate through the IntelliBase with no IrDA protocol software. See Tables 2 or 3
for the baud rate switch settings.
Installing The Dolphin Mobile IntelliBase
Mounting the Mobile IntelliBase Spring Arm Assembly
The adjustable mounting bracket holds the terminal securely in place and gives the user a variety of options for mounting the
Mobile IntelliBase. See the directions below for mounting the bracket.
To attach the bracket:
1. Loosen the turnscrew located on the side of the bracket.
2. Attach the bracket to the ball joint on the back of the Mobile IntelliBase and tighten the turnscrew.
Ball joint
Turnscrew