Filter
Top Products
6 - 12
To configure the Dolphin 7400/7450 terminal for communications, see the previous section on Configuring the Dolphin
Terminal.
Setting Up For Communications With The USB HomeBase
To use the USB HomeBase, you need the following equipment:
• USB HomeBase with power supply
•USB Cable
• CD with USB-IrDA drivers
• Windows® 98, Windows® Me or Windows® 2000 computer.
Note: The USB HomeBase does not support Windows
NT®
To install the USB HomeBase, follow these steps:
1. Plug in the power supply and connect it to the back of the USB HomeBase.
2. Plug the USB cable into the back of the USB home base.
3. Plug the other end of the USB cable into your PC.
At this point, a dialog box appears on your PC instructing you that the system has detected new hardware and it is searching for
the HHP USB-IrDA driver. Unless you have previously installed the USB HomeBase, the OS will be unable to find one and the
Found New Hardware Wizard screen shown below will display on your PC’s screen.
ActiveSync Connection Settings