GE UF-4000 Answering Machine User Manual


 
Customizing Your Machine
33
Programming
Your Machine
Fax Parameter Table
No. Parameter
Setting
Number
Setting Comments
01 CONTRAST
(HOME)
*1 Normal Setting the home position for the CONTRAST.
2 Lighter
3 Darker
02 RESOLUTION
(HOME)
*1 Standard Setting the home position for the RESOLUTION.
2Fine
3 S-Fine
4 Halftone
05 MEMORY
(HOME)
1 Off Setting the home position for memory transmission/copy
mode. (This setting can be temporarily changed by
pressing FUNCTION, 8, 9.)
*2 On
06 DIALING METHOD 1 Pulse Selecting the dialing method.
*2 Tone
07 HEADER PRINT *1 Inside Selecting the printing position of the header.
Inside : Inside TX copy area.
Outside : Outside TX copy area.
No print : Header is not printed.
2 Outside
3 No print
08 HEADER FORMAT *1 Logo, ID No. Selecting the header format.
2 From To
09 RCV'D TIME PRT *1 Invalid Selecting whether the machine prints the received date &
time, remote ID, percentage of reduction and page number
on the bottom of each received document.
2 Valid
10 KEY/BUZZER VOL. 1 Off Selecting the volume of the Key/Buzzer tone.
*2 Soft
3 Loud
12 COMM. JOURNAL
(HOME)
1 Off Selecting the home position of printout mode for COMM.
Journal Off/Always/Inc. only.
Off : Does not print
Always : Always prints
Inc. only : Prints only when communication has failed.
2 Always
*3 Inc. only
13 AUTO JRNL PRINT 1 Invalid Selecting whether the machine prints the journal
automatically after every 32 transactions.
*2 Valid
15 IN MODE *1 Tel Selecting IN (attended) mode as either Telephone Mode or
Fax/Tel Auto Switching Mode.
2 Fax/Tel SW
16 OUT MODE *1 Fax Selecting OUT (unattended) mode as either Fax Mode or
TAM Interface Mode.
2 TAM / Fax
18 OP CALL TIMER *1 20 sec. Selecting the length of time that your machine signals
(rings) for an incoming voice call in Fax/Tel Auto Switching
Mode. (See page 58)
2 30 sec.
3 40 sec.
4 50 sec.
19 OGM LENGTH
(TAM I/F)
1 1 sec. Setting for the OGM length of your TAM from 1 to 60
seconds. The machine will not start to detect SILENCE
until the time setting has lapsed.
(Default = 20 sec.)
--- ---
60 60 sec.
20 SILENT DET. (TAM I/F) 1 Invalid Selecting the Silent Detection Mode.
*2 Valid
Continued on the next page...