Filter
Top Products
13
DISPLAY CONTRAST SELECTION
NOTE: This setting is for the base only.
1. Press the flash/program button until “
SET CONTRAST
” shows in the
display. “
2
” is the default setting.
2. Press 1, 2 or 3 on the base number keypad or use the cid review (up or
down arrow) button on the base to scroll to your selection.
3. Press flash/program to store selection.
NOTE: You can press flash/program to go on to the next feature at any time.
To exit the menu, press flash/program repeatedly.
LOCAL AREA CODE SELECTION
1. Press the flash/program button until “
SET AREA CODE - - -
” shows in the
display. “- - -” is the default setting.
2. Use the handset or base number pad to enter your three digit area code.
3. Press flash/program to store selection.
NOTE: You can press flash/program to go on to the next feature at any time.
To exit the menu, press flash/program repeatedly.
To clear the local area code, press and release flash/program, until SET AREA
CODE is displayed. Then enter "000." Press flash/program again to confirm.