Installation Guide
Rio Rancho, NM 15
Setting Master/Slave Mode
WIth the DMTH4 connection configured, it is now
possible to set the Master/Slave operating mode. This
is done by selecting “Device Setup” from the Control
Panel Menu Bar. Select “Expansion Mode” from the
drop down menu and select “Slave.”
Initial Setup Hints
1) Right clicking the mouse is powerful in this inter-
face. You can activate quick access to a number of
setup functions (for example - right click in any
input box in the INPUTS tab). It also allows some
powerful cut and paste capabilities - especially in
the matrix setup and the filter (both input and
output).
2) Store startup settings in a startup default preset.
(See Storing and Recalling Presets in the online
HELP.)
3) Presets will take about 4 seconds to switch due to
the many parameters in the unit - audio will switch
off temporarily during a preset switch to avoid
feedback. If you need quicker response with no
interruption to the audio, use macros instead - try
using the macro recorder for making any changes.
The only changes that cannot be made in a macro
are filter adjustments.
4) Store presets after changes are made and not
before they are made.
5) Help is always available by clicking Help on the
Main Menu Bar. This Help is a comprehensive
resource and includes the latest revisions to the
software and firmware.
IMPORTANT: Any changes made during setup
must be saved in the unit via the preset menu.
For direct support from the factory, call (800) 821-1121
Ask for anyone in the SALES department. They will be
able to answer your setup and/or technical questions or
will get the correct person who can help on the phone.