Filter
Top Products
Installation Guide
Rio Rancho, NM 11
5. When the driver installation is complete, the final
page of the Wizard appears. Click Finish to
complete the LecNet2™ USB driver installation.
Installation of Additional Units
(or LecNet 2™ devices)
The Windows XP operating system regards all
Lecnet2™ devices as separate USB devices because
each has a unique serial number. Because of this,
Windows XP will want to install the USB driver every
time it encounters a LecNet2™ device whose serial
number it does not recognize. However, if the Lec-
Net2™ USB driver has already been installed at least
once before on the computer system, the process is
simplified because the LecNet2™ installation disk is not
required.
Use the following procedure if the LecNet2™ USB
driver was previously installed on the computer system.
1. On the first page of the Wizard, select Install the
software automatically (Recommended) and
click Next> to continue.
2. Windows discovers the previously installed USB
driver. It is likely that a dialog will open warning you
that the driver has not passed Windows Logo
Testing. Click Continue Anyway.
3. When the driver installation is complete, the final
page of the Wizard appears. Click Finish. It is now
possible to connect to the LecNet2™ device.