Filter
Top Products
Corporate Headquarters:
© 2005 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
QSIG/DPNSS Phone System with
Cisco EGW 2200 Integration Guide for
Cisco Unity Connection 1.1
Published November 22, 2005
This document provides instructions for integrating a QSIG/DPNSS phone system with Cisco Unity
Connection through a Cisco EGW 2200.
Integration Tasks
Before doing the following tasks to integrate Cisco Unity Connection with a QSIG/DPNSS phone
system through a Cisco EGW 2200, confirm that the Cisco Unity Connection server is ready for the
integration by completing the appropriate tasks in the Cisco Unity Connection Installation Guide.
The following task lists describe the process for creating, changing, and deleting integrations.
Task List to Create the Integration
Use the following task list to set up a new integration with a QSIG/DPNSS phone system. If you are
installing a new Cisco Unity Connection server by using the Cisco Unity Connection Installation Guide,
you may have already completed some of the following tasks.
1. Review the system and equipment requirements to confirm that all phone system and Cisco Unity
Connection server requirements have been met. See the “Requirements” section on page 2.
2. Plan how the voice messaging ports will be used by Cisco Unity Connection. See the “Planning How
the Voice Messaging Ports Will Be Used by Cisco Unity Connection” section on page 4.
3. Program the QSIG/DPNSS phone system. See the “Programming the QSIG/DPNSS Phone System”
section on page 5.
4. Set up the Cisco EGW 2200. See the “Setting Up the Cisco EGW 2200” section on page 6.
5. Create the integration. See the “Creating a New Integration with the QSIG/DPNSS Phone System”
section on page 6.