Filter
Top Products
35
Synergy 700 user guide ~ 7th Edition ~ 13th May ’02 ~ 4411
After the tone, speak your
outgoing message into the
handset. Press
#
when you
have finished. You will hear
a long beep, (throughout
recording r will flash on the
base unit display).
The prompt will announce,
“Your outgoing message is”
and then play your message.
The display will flash p and
after playing your message
you will hear the menu once
more.
Press and hold the
✘ button to
return the handset to standby.
recording capacity (13 minutes),
but you should try to keep it
short to allow time for recording
memos, or incoming messages
when using the alternative
Answer and Record outgoing
message. Your own outgoing
message will replace the
Answer Only pre-recorded
outgoing message, but it is
possible to reinstate it later if
you wish (see page 37).
Pick up the handset.
Press the ߜ button twice.
You will hear the main menu
announcement from the
handset earpiece.
Press the 8 button for the
outgoing message menu.
To record your own Answer
Only message, press the
4 button. The prompt will
announce, “Please speak after
the tone. To end recording,
press
#
”.
After the tone, speak your
outgoing message into the
handset. Press
#
when you
have finished. You will hear a
long beep, (throughout
recording r will flash on the
base unit display).
To record your own Answer Only
outgoing message
You can record your own
Answer Only outgoing
message to use instead of the
pre-recorded message already
available.Your outgoing message
can be up to a maximum
C
o
n
f
C
o
n
f
8
T
U
V
M
e
n
u
S
e
c
r
e
c
y
ANSWER MACHINE
Note
When recording your own Answer
Only outgoing message, please
remember not to invite your caller
to leave a message as the
Answer Only mode will not record
incoming messages.