Filter
Top Products
14
SETTING UP
Synergy 700 user guide ~ 7th Edition ~ 13th May ’02 ~ 4411
After the tone enter the day,
followed by the time using the
24 hour clock.
1 = Sun, 2 = Mon,
3 = Tues, 4 = Wed,
5 = Thur, 6 = Fri, 7 = Sat.
For example:
1 1415 = Sunday 2.15pm.
Or
5 0915 = Thursday 9.15am.
You will then hear your setting
confirmed.
Press the
✘ button twice to
return the handset to standby.
Note
If the day and time is entered
incorrectly, the prompt will announce,
“Incorrect, please set again”. Enter
the correct setting within 15 seconds
otherwise the handset will return to
standby mode. If the day and time
is entered incorrectly three times the
handset will return to standby.
Note
If you have any difficulties setting up
your Synergy 700 please call the
Helpline on 08706 058 047.
Please see the table below for your
Synergy 700 default settings.
If you wish to personalise your
answering machine settings, for
example record your own outgoing
message etc, please see “Setting up
and personalising your answering
machine” beginning on page 31.
The Synergy 700 answering machine
will now be switched ON and set to
its default settings so your Synergy 700
is now ready for use.
Synergy 700 Default Settings Table
Feature Default Setting
Day/Time Stamp Sunday 12:01 pm
Answer Delay Your answering
machine will answer
after 6 rings
Audible Message
Alert Tone
OFF
Outgoing Message Answer and Record
“Hello your call cannot
be taken at the
moment so please
leave your message
after the tone.”
Answer Mode ON
Base ringer level High
Base loudspeaker
volume
Level 5
PIN code 0000
Dialling mode Tone
S
e
c
r
e
c
y
If you wish to register additional
handsets, please see page 49.