Filter
Top Products
Synergy 700 user guide ~ 7th Edition ~ 13th May ’02 ~ 4411
SETTING UP
12
Place the handset on the base station.
The red charging light will come on.
The battery symbol is shown on the
display during charging. Leave to
charge for at least 16 hours.
Once the handset is fully charged, the
display shows a full battery symbol.
BATTERY LEVELS
WEAK HALF-FULL FULL
3 Charge the handset battery
pack for at least 16 hours
2 Install the battery pack
Battery low warning
If the handset battery symbol is empty
and flashing, and you hear a warning
beep every 10 seconds, you will need
to recharge your handset before you
can use it.
Helpline
If you are experiencing difficulty,
please call the Synergy Helpline on
08706 058 047.
A battery pack is supplied.
Install the battery pack by unclipping
the battery compartment cover,
then plug the battery pack connector
in (as shown in illustration) and lower
the battery pack into recess then
replace lid.
Your Synergy 700 handset registers
to the base automatically. The icon
is shown on the display and SYNERGY
HS1 will be displayed.