Filter
Top Products
21
Help
If you have any problems using your Response 75, this section gives
you the most common solutions
Response 75 – Edition 7 – 26th October ’00 – 3370
Call counter does not light up
Check that your Response 75 is correctly
connected to the mains and that the
power cable is inserted correctly into
the back of your Response 75.
If you have inserted the back-up battery
before connecting to the mains power
you will need to reset your Response 75.
No dialling tone
Check your line cord is correctly
connected to the socket and your
Response 75.
Response 75 display is flashing
continuously
This indicates an error. Press any
button on your answering machine.
Flashing should stop and the answering
machine should reset to its settings on
first ‘power up’. Unplug the line cord
and power cord. Wait 5 minutes and
then replug.
Press the Answer on/off button on your
answering machine. Flashing should
stop and Response 75 should reset to
settings on first ‘power up’.
Response 75’s battery low indicator is on
The back-up battery is either low in
power, missing or incorrectly installed.
Open the battery compartment. If
battery is correctly in place, try replacing
it with a new 9V alkaline battery. When
operating at normal power the battery
light remains off.
Incoming message does not record
Make sure your Response 75 is set to
answer-on mode and that the memory
is not full. When the memory is full, the
display will flash F.
You cannot hear messages or
incoming calls
Your Response 75’s volume may be set
too low. Adjust the volume by pressing
+
on the volume control.
You experience a power cut
If a working battery is installed inside
your Response 75, its settings and
messages should be saved until power
resumes. It will not be able to record
any new messages, however.