Filter
Top Products
Your Response 75 announces
the current ring delay and the
message counter displays the
selected answer delay setting.
Keep holding the
Skip
ᮣ
button.
Your Response 75 announces
and displays the answer delay
options.
When you hear your desired
setting, release the
Skip
ᮣ
button. After 2 seconds your
Response 75 will announce the
new answer delay setting and
then return to ‘Answer On’
mode. The setting will be shown
on the display.
13
Response 75 – Edition 7 – 26th October ’00 – 3370
Receiving messages
To receive incoming messages
After following the set-up procedure
your Response 75 is ready to receive
messages.
To check the answer delay
setting
Press the Skip
ᮣ
button.
You Response 75 will announce
the current ring delay setting
and show the setting on the
display.
Skip
ᮣ
Your Response 75 will
automatically record an
incoming message when it
is connected to your phone
socket and is set to
‘Answer On’.
When your Response 75 has
received new messages (or
memos) it will beep
(see
‘Audible Message Alert to switch
off’) and the display will show
the number of messages
received. If you have more
than 9 messages, the display
will flash 9.
If the memory is full then it will
announce,
“Memory full, thank
you for calling” and disconnect
the line.
Your Response 75 can record
up to 30 messages and memos,
within a total recording time
of 36 minutes. If the memory
capacity is full, the display will
flash
F and your answering
machine will not record further
messages.
Please note
Two minutes is the maximum time
allowed for each incoming message.
If the maximum message length is
reached, your Response 75 will
announce, “Thank you for calling”
and disconnect the line.