Filter
Top Products
71General information
BT Glide – Edition 07 – 20.01.06 – 7163
If you experience any problems, please call the Helpline on 0870 605 8047
Product disposal instructions
The symbol shown here and on the
product means that the product is
classed as Electrical or Electronic
Equipment and should not be disposed
with other household or commercial waste
at the end of its working life.
The Waste of Electrical and Electronic
Equipment (WEEE) Directive (2002/96/EC)
has been put in place to recycle products
using best available recovery and recycling
techniques to minimise the impact on the
environment, treat any hazardous
substances and avoid the increasing landfill.
Product disposal instructions for
residential users
When you have no further use for it, please
remove any batteries and dispose of them
and the product as per your local
authority’s recycling processes. For more
information please contact your local
authority or the retailer where the product
was purchased.
Product disposal instructions for
business users
Business users should contact their
suppliers and check the terms and
conditions of the purchase contract and
ensure that this product is not mixed with
other commercial waste for disposal.
Technical information
How many telephones can you have?
All items of telephone equipment have a
Ringer Equivalence Number (REN), which is
used to calculate the number of items which
may be connected to any other telephone
line. Your BT Glide has a REN of 1. A total
REN of 4 is allowed. If the total REN of 4 is
exceeded, the telephone may not ring.
With different telephone types there is no
guarantee of ringing, even when the REN is
less than 4.
Switchboard compatibility
This product is intended for use within the
UK for connection to public switched
telephone networks and compatible
switchboards, which support tone dialling
and timed break recall. If in doubt please
consult your network service provider.
Dialling mode
Your BT Glide is set to Tone dialling.
Some older switchboards may require
Pulse dialling. To change the dialling mode,
see ‘Set the dialling mode’,
page 60.
PABX access code
If you are connecting your BT Glide to a
switchboard/PBX you may need to enter an
access code (e.g. 9) in order to get an
outside line, see ‘Set the PABX (switchboard)
code’,
page 61. So that the switchboard has
time to pick up an outside line, you may also
need to add a Pause after the access code in
numbers stored in the phonebook.