Filter
Top Products
9
WALL MOUNTING
INSTRUCTIONS
The phone unit may be mounted on a
standard wall plate.The mounting
bracket will mount on the telephone
with the wide end of the bracket
towards the bottom of the phone.
1. Plug one end of the flat telephone
line cord into the jack marked TEL
LINE located on the back of the
telephone.
2. Insert the plug of the AC adapter
into the jack marked DC 12V
located on the back of the
base unit.
3. Place the mounting bracket on the
telephone with the wide end of the
mounting bracket towards the bot-
tom of the phone. With the back of
the unit facing up insert the supplied
mounting bracket’s upper tabs into
the base’s upper tab slots. Depress
the tabs located at the bottom of the
mounting bracket and insert the
tabs into the lower tab slots. Release
the tabs to lock the mounting brack-
et into place.
4. Pull up on handset knob and turn
so that the knob extends out. This
will hold the handset in the place
when the phone is wall mounted.
5. Plug the flat telephone line cord
into the wall plate jack, then align
the mounting bracket’s key hole
slots with the wall plate studs and
slide the base of the phone down-
ward to secure it on the wall.
6. Plug the AC adapter into an
electrical outlet.
7. Set the TONE/PULSE switch
located on the back of the base to
correct dialing mode. Please check
with your local telephone company
if uncertain of the type of service.
8. Plug one end of the coiled hand-
set cord into the bottom of the
handset. Plug the other end of the
handset into the modular jack
marked HANDSET located on the
left side of the phone. Place receiver
in the cradle.
Getting Started
E
N
G
L
I
S
H
BSC500Eng_8.27.qxd 8/27/03 9:54 PM Page 9