Filter
Top Products
8
DESK MOUNT INSTRUCTIONS
Follow these instructions to place the
phone on a desk or table top using the
supplied bracket.
1. Plug one end of the long flat tele-
phone line cord into the jack
marked TEL LINE located on the
back of the telephone. Route the
cord through the narrow groove
and plug the other end into the
telephone wall jack.
2. Insert the plug of the AC adapter
into the jack marked DC 12V
located on the back of the base
unit. Route the cord through the
narrow groove and plug the other
end into an electrical outlet.
3. Place the mounting bracket on the
telephone with the wide end of the
mounting bracket towards the top
of the telephone. Insert the mount-
ing bracket’s lower tabs into the
base’s lower tab slots. Depress the
tabs located at the top of the
mounting bracket and insert them
into the upper tab slots. Release the
tabs to lock the mounting bracket
into place.
4. Plug one end of the modular coiled
handset cord into the handset. Plug
the other end into the jack marked
HANDSET located on the lower left
side of the telephone. Place the
handset in the cradle.
5. Set the TONE/PULSE switch locat-
ed on the back of the base to
correct dialing mode. Please check
with your local telephone company
if uncertain of the type of service.
6. Adjust the LCD display to desired
viewing angle.
Warning: Use only the power adapter
provided with this telephone. Use of
any other adapter may damage the
product and result in injury.
Getting Started
BSC500Eng_8.27.qxd 8/27/03 9:54 PM Page 8