Filter
Top Products
2410/5410 Phone Page 52
15-601076 Issue 06a (16 July 2009)IP Office
7.3 Longhand Programming Mode
1. Press Admin or Admin 1. See Display Key Programming .
2. To switch to longhand programming mode, press Expl? .
3. Press Next until the required function required is shown, then press Selct .
4. If the function requires some data to be entered, [ ] is shown at the bottom of the display. Enter the data using the
normal telephone keypad.
5. The upper part of the display reverts to showing the functions currently assigned to each and .
6. To move between the pages of display keys, press and .
7. To select the display key against which to program the new function, press or .
Caution
Do not select the slot used for the Admin function. Replacing this function will lock the phone for further
programming until reset through the telephone system.
8. If the display slot is not already used, the display shows BUTTON PROGRAMMED!.
· To end programming, press EXIT.
· To continue programming other functions, press Cont.
9. If the display slot already has a programmed function, the display shows FEATURE ON BUTTON. Press or
until Repla, Keep and Delet are shown along the right-hand edge of the display.
· Press Repla to replace that existing function with the one just programmed. BUTTON PROGRAMMED! is
displayed.
· To keep the existing function and forget the function just programmed, press Keep .
· To delete the existing function and forget the function just programmed, press Delete .
49