Filter
Top Products
68
Connection Settings
Never use the following "Connection" menus to
change any phone settings unless otherwise in-
structed by your carrier. Altering any of these
settings may disable Web access capability.
Your phone can have up to 4 sets of the server IP
(Internet Protocol) addresses and Port numbers to ac-
cess your service provider’s website. These may already
be preset or be advised by your service provider.
To change the settings, enter your 4-digit Security Code.
Changing IP addresses in “Web Link A”
1. Scroll to “Web Link A” and press
F
.
2. Enter Link A Primary IP Address and press
F
.
3. Enter Link A Primary Port number and press
F
.
4.
Enter Link A Secondary IP Address and press
F
.
5.
Enter Link A Secondary Port number and press
F
.
Changing IP addresses in “Web Link B”
Scroll to “Web Link B” and press
F
, and follow the
above steps 2 through 5 for Link B.
Notes: 1.
An IP address must be 12-digit long to enter. If you have,
for example, 123.45.67.8, then enter
1
2
ABC
3
DEF
,
0
4
GHI
5
JKL
,
0
6
MNO
7
PQRS
,
0
0
8
TUV
.
2.Your phone may display the stored IP addresses
or Port numbers in the above steps. Then press
F
to keep them unchanged.
QNC Info.
The “Username” and “Password” are normally blank.
The “Auth.Type” is normally set to “None”. Altering any
of these settings may disable the Web access.
Packet Info.
To enable accessing with packet mode, the “Username”
and “Password” should be programmed as advised by
your service provider. The “Auth.Type” is normally set
to “Auto”. Altering any of these settings may disable
the Web access.
Current Link
This is normally set to “Web Link A”. Altering to “Web
Link B” may disable the Web access.
Service
This mode is normally set to “Auto”. Altering to “Packet”
or “QNC” may disable the Web access.