Filter
Top Products
6
Getting Started
Telephone base installation (2-line jack)
If you have a 2-line jack, install the base as shown below. Choose a location away
from electronic equipment, such as personal computers, television sets or microwave
ovens. Avoid excessive heat, cold, dust or moisture.
Plug base power
cord transformer
into electrical outlet
Connect the black line cord to jack
labeled LINE1/L1+L2
NOTE:
Use only the power
cord supplied with this product.
If you need a replacement, call
1 800 222–3111.
Be sure to use an electrical outlet
not controlled by a wall switch.
Connect handset cord
to corded handset
Line 1 + Line 2
Line identification
To identify phone lines, press SPEAKERPHONE,
then call one of your telephone numbers. If you
hear a busy signal, Line 1 is the number you
called. If Line 2 rings, it is the number you called.
ATT-2562CIB-d4.qxd 12/29/2003 6:20 PM Page 6