Filter
Top Products
15
Telephone Operation
Base settings
Ringers
At this menu you can set default ring volumes, or turn the
ringer off. You can also select one of six call melodies.
Settings are selectable for the intercom and each line.
Follow the menu instructions to select the volume and
melody you prefer, then press OK or SAVE to confirm.
Call screening
Call screening lets you hear messages as callers leave
them. Press ON or OFF, then press OK to confirm.
Set pulse/tone
Factory default setting for both lines is TONE. Change this
to PULSE only if you do not have touch-tone dialing ser-
vice (select line, select TONE or PULSE, then press OK).
Keypad tone
The handset is factory programmed to beep at each
keypress. Press ON or OFF, then press OK to confirm.
Contrast
At this menu you can adjust screen contrast to one of 16
levels. Use the <> buttons to select the level you prefer,
then press OK to confirm.
Enhanced mode
Use the ^V buttons to select On, Off or Auto for all
handsets, then press OK to confirm. When on, this
mode may improve sound quality and range, but will use
more battery power. In Auto mode, handsets switch to
Enhanced Mode when reception is poor.
Rename
Select Rename to change the name (up to 14 letters) that
identifies your handset in all Intercom/Transfer menus
(see page 17 to enter letters). Press SAVE to confirm.
Deregister all
Use this option with caution. It will make all handsets
unusable until each has been re-registered (see page 36).
BASE
RDL MEMMENU
MAILBOXES
CALL HISTORY
SETUP BASE
DISPLAY BASE ID
^ V
OK
CALL SCREENING
RINGERS
SET PULSE/TONE
KEYPAD TONE
^ V
OK
ENHANCED MODE
CONTRAST
RENAME
DEREGISTER ALL
^ V
OK
Select MENU
Select SETUP BASE
Scroll to choose desired item
Press OK to select
ATT-2562CIB-d4.qxd 12/29/2003 6:23 PM Page 15