Open as PDF
AT&T IP Flexible Reach Service
Nortel BCM50 Release 3.0 SIP Configuration Guide
© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T
logo and all other AT&T marks contained herein are trademarks of AT&T
Intellectual Property and/or AT&T affiliated companies. All other
marks contained herein are the property of their respective owners.
The BCM Monitor application can be downloaded to an administrator’s PC from
the BCM and pointed at a specific BCM’s IP address for monitoring. Multiple
instances of the BCM Monitor application can be used on a single PC to monitor
several remote BCM systems at the same time.
Backward version compatibility is supported.
All of the registered IP devices can be viewed with the BCM Monitor. The screen
shot below depicts IP Phone type, DN number and IP address of each registered
IP phone. Additionally, if the device is active on a call the RTP session
information is also displayed.
Figure 24: IP Device Listing
The end-to-end RTP sessions per IP call can also be displayed with the BCM
Monitor. The example below depicts an end-to-end call.
Issue 0.7 Page 31 of 37