AT&T BCM50 IP Phone User Manual


 
AT&T IP Flexible Reach Service
Nortel BCM50 Release 3.0 SIP Configuration Guide
© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T
logo and all other AT&T marks contained herein are trademarks of AT&T
Intellectual Property and/or AT&T affiliated companies. All other
marks contained herein are the property of their respective owners.
TABLE OF FIGURES
Figure 1: AT&T IP Flexible Reach Network ..................................................................... 8
Figure 2: BCM50 Software Version Number................................................................... 11
Figure 3: BCM50 Lists of Applied Patches...................................................................... 12
Figure 4: Available VoIP Trunks...................................................................................... 14
Figure 5: Application Resource availability of SIP (or IP) Trunks .................................. 14
Figure 6: Assigning Line Pool to IP Trunks..................................................................... 15
Figure 7: Assigning DN to Line Pool ............................................................................... 15
Figure 8: Configuring General DN Length....................................................................... 17
Figure 9: Configuring Public Received Number Length and Dialing Plan...................... 17
Figure 10: Configuring Private Received Number Length............................................... 18
Figure 11: Assigning a Route for IP Trunks..................................................................... 19
Figure 12: Assign Code to Access IP Trunk Routes......................................................... 20
Figure 13: Selecting IP Trunk Module ............................................................................. 21
Figure 14: Sip Proxy Parameters ...................................................................................... 21
Figure 15: Outbound Proxy Table for failover to secondary AT&T IPBEs..................... 22
Figure 16: SIP Media Parameters ..................................................................................... 23
Figure 17: Configuring analog DNs for fax...................................................................... 24
Figure 18: Media Gateway Port Ranges........................................................................... 25
Figure 19: Configuring DID for Outgoing Calls .............................................................. 26
Figure 20: Configuring DID for Incoming Calls.............................................................. 27
Figure 21: Display DID on IP Set LCD............................................................................ 28
Figure 22: Assign Line Pool to IP Sets............................................................................. 29
Figure 23: System Monitoring Example........................................................................... 30
Figure 24: IP Device Listing............................................................................................. 31
Figure 25: RTP Session Information ................................................................................ 32
Figure 26: Line Monitor Information ............................................................................... 32
Figure 27: System Resources............................................................................................ 33
Figure 28: BCM50 Alarms Page....................................................................................... 34
Figure 29: Log Management............................................................................................. 35
Figure 30: Configuring Destination Code with Wildcard................................................. 36
Issue 0.7 Page 3 of 37