Filter
Top Products
A. Power and Phone Line Connection
Connect the phone cord and the AC
adapter/charger to the DIALOGUE TTY as
shown below. The AC adapter/charger pro-
vides power to operate DIALOGUE TTY while
automatically charging the rechargeable bat-
tery in the battery compartment.
You should only use the AC adapter/charger
supplied with your TTY. When the TTY is not in
use, turn the power off but keep the charger
plugged in.
B. Loading Paper Into Printer
Figure 4 - Pulling printer paper through
its cover
Figure 3 - Installing printer paper
Figure 2 - Removing paper tray cover
AC Outlet
AC Adapter
CHAPTER 4
INSTALLATION
If your TTY is equipped with a built–in printer,
follow these steps for loading printer paper.
Use 2 1/4" wide thermal paper only. Printer
paper can be ordered from Ameriphone or any
office products supplier.
1. Turn your TTY on.
2. Turn the printer switch on.
3. Remove the paper cover by pressing
down with both thumbs and sliding it
towards the back (see Figure 2).
4. Cut the paper to form a wedge as a lead.
Push the end of the paper as far as pos-
sible into the slot at back of the printer
(see Figure 3).
5. Pull the paper once it comes out of the top
or press the key several times to
advance the paper.
6. Feed the paper through the tear off slot in
the paper cover (see Figure 4). Deposit
the paper into the paper compartment
and adjust the roll to eliminate any exces-
sive slack. Slide the paper cover into po-
sition. Your printer is now ready to print
your conversations.
Phone Wall
Outlet
Telephone or Signaling
Devices (Optional)
Phone Cord
6