Filter
Top Products
1. Hold down and press 1 .
2. DIR NAME: appears on screen.
3. Type in a name (9 letters max) and then
press .
4. Enter the complete phone number and
then press .
5.
ASCII NUMBER? Y/N appears on screen.
6. Press Y (for Yes) for ASCII number.
7. Use and keys to
change / save the next four ASCII
parameters (Duplex, speed, parity,
carriage return & line feed).
8. When finished, hold down and
press to return to normal
TTY operation.
CHAPTER 7
(CONTINUED)
CHANGE MODES? Y/N
300. HALF. ORIG. 8NI
To make a call in ASCII code to a data base or
someone’s personal computer, follow these
steps:
1. Turn on your TTY
2. While holding down and left
press A to go to the ASCII menu.
“ASCII CODE (ON) ” is displayed.
3. Press to select ASCII (or
to not select).
4. Next, the screen summarizes the ASCII
mode settings and then asks if you want to
change modes .
5. Type Y to change. Press or
to answer the rest of the prompts
related to ASCII data format.
6. When finished, the screen shows the set-
ting you selected: ,
for example.
7. Dial the telephone number as you usually
would.
8. Conduct your conversation in the normal
fashion. After the conversation is over,
hang up and turn off your TTY. It will auto-
matically return to the regular Baudot
mode of communication for regular TTY
operation.
You can also receive ASCII calls. DIALOGUE
III/III-P TTY s equipped with ASCII code auto-
matically switch to ASCII mode of communica-
tion when there is an ASCII incoming call. Answer
the call and carry on in the normal fashion. If you
do not use the ASCII feature, we recommend you
5. Hold down and press
to return to the screen prior to this function.
L. ASCII Code
ASCII code allows you to communicate with
someone who uses a computer as their com-
munication device and to access computer data
bases such as COMPUSERVE, ABLEDATA or
DEAF NET. Your TTY is already equipped with
ASCII code, it is preset to communicate in the
following mode settings:
• 300 Baud rate of transmission
• Half Duplex
• Answer
• Displays left to right for easier reading
disable the automatic ASCII detection by setting
the ASCII Tone to 0 (zero) seconds in Step 5, as
follows:
1. Turn on your TTY
2. While holding down and left press
A to go to ASCII menu. is
displayed.
3. Press to select ASCII.
4. Next, the screen summarizes the ASCII
mode settings and then asks if you want to
change modes
5. Type Y to change. Press several
times until you get to the screen that
displays At this point,
hit twice until the setting
changes to 0 (zero) seconds.
6. Press until you get back to the nor
mal way of operation. You have successful
ly changed the Auto-detection feature to OFF.
Figure 6 - Battery compartment
Save ASCII Phone Number
You can save the phone number as an ASCII
phone number. When you auto dial the ASCII
phone number, your
DIALOGUE TTY will
automatically set up the call without going
through the manual ASCII set up procedures.
CHANGE MODES? Y/N
ASCII CODE (ON)
ASCII TONE: (3) SEC.”
18