Ameriphone IIIP TTY Telephone User Manual


 
When using your telephone equipment, always fol-
low basic safety precautions to reduce the risk of
fire, electric shock, and injury to persons, including
the following:
1. Read and understand all Instructions.
Observe all warnings and other markings on
the product.
2. During thunderstorms, avoid using tele-
phones except cordless models. There may
be a slight chance of electric shock from
lightning.
3. Do not use a telephone near a gas leak. If
you suspect a gas leak, report it immediate-
ly, but use a telephone away from the area
where gas is leaking.
4. Do not use this product near water, or when
you are wet. For example, do not use it in a
wet basement or shower, or next to a swim-
ming pool, bathtub, kitchen sink or laundry tub.
Do not use liquids or aerosol sprays for clean-
ing. If the product comes in contact with any
liquids, unplug any line or power cord immedi-
ately. Do not plug the product back in until it
has dried thoroughly.
5. Install this product in a protected location
where no one can trip over any line or
power cord. Protect cords from damage or
abrasion.
6. If this product does not operate normally,
read “troubleshooting” section. If you cannot
resolve the problem, or if the product is dam-
aged, refer to the Ameriphone Warranty. Do
not open this product except as may be
directed in this owner’s manual. Opening this
product or reassembling it incorrectly may
expose you to hazardous voltages or other
risks. Opening this product automatically
voids the warranty.
7. If this product uses batteries as power back-up
during power outages, replace batteries only
as described in this owner’s manual. Do not
burn or puncture used batteries — they con-
tain caustic chemicals.
8. Unplug this product from the wall outlet and
refer servicing to qualified service personnel
under the following conditions:
A. When the power supply cord or plug is
damaged or frayed.
B. If liquid has been spilled on the product.
C. If the product has been exposed to rain or
water.
D. If the product does not operate normally by
following the operating instructions. Adjust
only those controls that are covered by the
operating instructions because improper
adjustment of other controls may result in
further damage.
E. If the product has been dropped or
appears damaged.
ADDITIONAL SAFETY NOTES FOR CANADI-
AN USERS
NOTICE: The Canadian Department of
Communications label identifies certified equip-
ment. This certification means that the equipment
meets certain telecommunications network protec-
tive, operational and safety requirements. The
department does not guarantee the equipment will
operate to the user's satisfaction.
Before installing the equipment, users should
ensure that it is permissible to be connected to the
facilities of the local telecommunications company.
The equipment must also be installed using an
acceptable method of connection. The customer
should be aware that compliance with the above
conditions may not prevent degradation of service
in some situations. Repairs to certified equipment
should be made by an authorized Canadian main-
tenance facility designated by the supplier. Any
repairs or alteration made by the user to this equip-
ment, or equipment malfunctions, may give the
telecommunications company cause to request the
user to disconnect the equipment.
Users should ensure for their own protection that
the electrical ground connections of the power utili-
ty, telephone lines and internal metallic water pipe
system, if present, are connected together. This
precaution may be particularly important in rural
areas.
CAUTION: Users should not attempt to make
such connections themselves, but should contact
the appropriate electric inspection authority, or
electrician, as soon as possible.
NOTICE: The LOAD NUMBER (LN) assigned to
each terminal device denotes the percentage of the
total load to be connected to a telephone loop
which is used by the device, to prevent overloading.
The termination on a loop may consist of any com-
bination of devices subject only to the requirement
that the sum of the load numbers of all devices does
not exceed 100.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
F. If the product exhibits a distinct change in
performance.
9. If this product has a polarized plug with one
wide prong, it may not fit in non-polarized out
lets. Do not defeat the purpose of these
plugs. If they do not fit in your outlet, the outlet
should be replaced by an electrician.