Filter
Top Products
21
GETTING STARTED APPENDIX
USING THE PC MASTER STATION
Searching for a station, zone or remote site
from the list
A
Searching for a station or zone in your site by
entering the name [NAME SEARCH]
Select [NAME SEARCH] either in the standby mode
1
(→P. 19) or the SEARCH LIST. (→P. 20)
Click
2
to display the Dial keys window.
Enter a name by using the dial keys.
3
e.g.)
When searching for "MASTER004";
Click the dial keys as follows.
M
00
AS
4
TER
(4 times) (3 times) (8 times) (8 times) (4 times)(twice)
The entered characters are displayed here.
All the station and/or zone names that include the entered
characters in your site are displayed in the list.
The search is narrowed down whenever a character is
*
added.
NOTE:
You can also select a station from the list by using after
you select [NAME SEARCH] in step
1
.
To delete the just entered character:
Click
.
To enter the same characters or characters on the
same dial key sequentially:
(e.g.: To enter “AB”)
1. Enter “A”. (Click the dial
key once.)
2. Click
.
3. Enter “B”. (Click the dial key twice.)
Click
4
to select the target station or zone (so that
it is highlighted) from the list.
You
*
can select up to 5 stations and/or zones by clicking
. (See below.)
Start calling (talking), monitoring or paging by
5
following the procedure for the corresponding
performance. (→P. 25-27)
T
o select two or more stations and/or zones from the
list:
Click
1)
with the target station or zone
highlighted.
The station or zone is checked.
Click
*
again to clear the check.
Repeat step 1) to select more stations and/or zones.
2)
You can select up to 5 stations and/or zones.
*
To select 5 stations and/or zones, after checking 4
stations and/or zones, select the 5th one so that it is
highlighted. (The 5th station or zone is not checked.)
You cannot select two or more remote sites.
*