Filter
Top Products
27
GETTING STARTED USING THE SYSTEM APPENDIX
SETTING AND ADJUSTMENT
Searching for a station, zone or remote site
Read this section before you perform calling, monitoring or paging for the fi rst time to learn how to search for stations, zones or remote sites.
The search can be performed in the following search methods by using the search items, dial keys or speed dial buttons to suit your needs.
PERFORMING CALLING, MONITORING AND PAGING ON
THE MASTER STATION
The following describes how to operate the master station to perform calling, monitoring and paging.
If your network direct system includes a PC master station (IS-SOFT), refer to the “OPERATION MANUAL” for the PC master
*
station (IS-SOFT) for details about operating it.
The term “a remote site” used in this manual means “a network direct system in a remote site”.
*
To make a communication (or calling, paging, etc.) between your site and a standard (IP) system in a remote site, also refer to the
*
“OPERATION MANUAL” for the standard (IP) system.
Searching for a station, zone or remote site
from the list (→P. 29)
Search items:
A
,
B
,
C
,
D
,
E
(
E
is
for a remote site.)
Searching for a station or zone by number
using the dial keys (→P. 31)
Searching for a station, zone or remote site
from the placed call or received call list (→P. 32)
Search items:
F
,
G
Selecting a station, zone or remote site by
using the speed dial buttons (→P. 32)
■
Basic procedure for selecting the search items
The search items
A
–
G
can be selected from the standby mode or the SEARCH LIST.
* The items
A
and
B
can be selected from both the standby mode and the SEARCH LIST.
* A remote site can be selected by using the search item
E
,
F
,
G
, or the speeds dial buttons.
[In the standby mode]
Press the corresponding button on to select the target search item
A
,
B
,
F
or
G
by following the key map.
Speed dial buttons
Search items
A
NAME SEARCH (→P. 29)
B
STATIONS BY AREA (→P. 30)
F
PLACED CALLS (→P. 32)
G
RECEIVED CALLS (→P. 32)
Press to display the SEARCH LIST.
Key map