Filter
Top Products
25
GETTING STARTED USING THE SYSTEM APPENDIX
SETTING AND ADJUSTMENT
Transferring to another master station
You can transfer a call received from a door station to another
master station while communicating with it (communication
transferring), as well as setting calls to be automatically
transferred in the "INITIAL SETTING".
For a call from another master station, you can transfer it
*
when you are communicating with it. However, you cannot
transfer the communication to a remote site.
■
Communication transferring
Receive a call and communicate with it. (→P. 20)
1
Press
2
TRANSFER
.
Press
3
to select the master station in your site
to which you want to transfer the call (so that it is
highlighted) from the list.
Press
4
TALK
or
ZOOM/WIDE
.
While transferring, a sound rings at the source station to
*
indicate a transfer.
Press
5
OFF
to enable the communication between
the station that called you and the transfer target
station.
NOTE:
You cannot transfer a call from a remote site to another remote site.
■
Call transferring
You can transfer a call to the designated master station (in your
site or a remote site) automatically (without answering it) by the
"TRANSFER" settings in the "INITIAL SETTING". (→P. 18)
This function is useful when you are absent or you cannot
*
receive and answer a call.
When transferring to a remote site, a master station in the
*
remote site should have been registered as the pilot station
of the site.
The following settings can be made.
1
Transferring a call to the designated master station or
remote site automatically (→P. 18 [CALL TRANSFER],
[TRANSFER DESTINA])
2
Setting the delay time of triggering transferring after a call is
received (→P. 18 [TRANSFER DELAY])
3
Setting a schedule for call transferring in the System setting
on a PC (→P. 18 [SCHEDULE TRANSFER], [SCHEDULE
DESTINA])
* When both
1
and
3
are set,
1
takes priority.
Blinks in red.
Appears while the transfer is being performed.
or