Filter
Top Products
27
If your M6310 has not been connected to the wall jack/power supply or
you are moving the set to another location, use these instructions to
make all the required connections.
To connect your M6310 to the telephone wall jack and AC power:
1. Use the silver-grey line cord (7.5 feet/2.25 meters) and the AC
adapter unit provided with your M6310. Contact your System
Administrator or Customer Service Representative if you need
a replacement for a missing or damaged adapter.
2. Remove the stand F.
3. Insert one end of the line cord into the appropriate jack (A) located
underneath the M6310. The connector clicks into place when
correctly inserted.
4. If the handset has not been connected, insert one end of the curly
handset cord into the appropriate jack (C). Feed the cord through
the restraining tab (D) so that the cord falls to the left side of the
set. Insert the other end of the handset cord into the handset.
Connecting your M6310
Figure 1 – M6310 connections
B
C
D
E
F
G
➤
➤
➤
➤
➤
➤
➤
A
➤
➤
6310 E UG2.qxd 1/24/05 3:49 PM Page 27