Filter
Top Products
Time and Date
To set the time and date on your M6310:
1. Press b.
2. Press
@ until Time and Date Set? is shown on the display.
3. Press
a.
4. Enter the date using the format shown on the display.
5. Enter the current time based upon the 24 hour clock.
6. Press
a to save the new time and date settings.
7. Press
b or r to exit programming mode.
To select the time and date display format:
1. Press b.
2. Press
@ until Time and Date Format? is shown on the
display.
3. Press
a.
4. Press
@ until the desired format is shown on the display.
5. Press
a to save the new format setting.
6. Press
b or r to exit programming mode.
Call Timer
The Call Timer uses the display to show the time elapsed since the start
of a normal call (the timer appears on the display 5 seconds after the
call starts and remains on the display 5 seconds after you end the call).
Follow the instructions below to enable the Call Timer.
To enable the Call Timer:
1. Press b.
2. Press
@ until Call Timer? is shown on the display.
3. Press
a.
4. Press
@ to enable or disable the Call Timer.
5. Press
a to save the new setting.
6. Press
b or r to exit programming mode.
12
Setting up local features: continued
6310 E UG2.qxd 1/24/05 3:49 PM Page 12