Filter
Top Products
Post Installation Configuration 39
Therefore, if the caller dials 900, the system receives the extension of the
3Com IP Conferencing Module and the port number for the private
conference from the dial plan. The system can route the call to the 3Com
IP Conferencing Module.
3Com Public IP Conferencing Module Configuration
You must configure the dial plan to complete the 3Com Public IP
Conferencing Module configuration. The dial plan uses the private
conference dial plan if it is configured; otherwise, you need to configure
the dial plan for Public conference.
The only change required is in the dial plan prefix entry table because in a
Public conference, you need to define a range of extensions rather than a
single extension.
For example, using the above configuration and taking the case that the
extensions range from 700-799, the table entry can be as follows:
If the caller dials 700, the system receives the extension of 3Com IP
Conferencing Module and the port number for the Public conference
from the dial plan. The system can route the call to the 3Com IP
Conferencing Module.
Test E-Mail
Notification
Setup
Run the following test to ensure that the e-mail setup works correctly.
1 Log in to the server as root.
2 At the prompt, enter:
/usr/sbin/sendmail user@domain.com
From: sender@domain.com
To: user@domain.com
Subject: test e-mail
[blank line]
test1
test1
test1
3 Ctrl-D
/ ID Entry Digits Min Max Class PrioRoute
/ --- ----- ------ --- --- ----- ---------
Table Entry Create 1 7 7 3 3 internal0900