Filter
Top Products
10 CHAPTER 1: PRE-INSTALLATION
Figure 1 Network diagram - single server
Post-installation
Setup
After you run the installation script, you need to configure the following:
Setting up a Route to the Conference Servers
You must configure the NBX dial plan with a route to your conference
server. If your implementation has only one server, then a route to a
single endpoint is required.
Setting up a Route to the Conference Attendant Servers
As with the conference server, it is necessary to configure a route for the
conference attendant server. The NBX dial plan is used for this purpose.
Test E-Mail Notification Setup
You must test the e-mail setup by logging in to the system and sending
an e-mail message using Send-only Simple Mail Transfer Protocol (sSMTP).
If you fail to receive the test e-mail message, you can check for errors in
/opt/logs/vcx-linux/maillog.
Gathering Site
Information
The 3Com NBX servers communicate with each other using IP addresses.
These addresses must be dedicated (static) and must be compatible with
your network design.
Conference server pool
Conference server
Presence server
Master database
User database
Web server
NBX server