Filter
Top Products
Post Installation Configuration 37
7 Type a port number. A SIP endpoint is identified by the IP and port
combination.
Port 5060 is set as the default during installation and typically does not
need to be changed.
8 Type the maximum number of simultaneous sessions. Each session
requires one system device license. See the NBX Administrator’s Guide for
more information.
9 Click OK or Apply to save your changes.
When you click Apply, the system adds a trusted endpoint. Click SIP
Applications > Trusted SIP Interfaces to verify.
10 Configure the dial plan.
You must add an extension list to the dial plan to support routing of
extensions to the conference server or edit the extension list, if one has
already been created.
To configure the settings of the Conference Attendant for restricted
conferences:
1 See the NBX Administrator’s Guide for more information about the
details in these steps.
2 Log in to the NBX NetSet utility using the administrator login ID and
password.
3 Click SIP Applications > 3Com IP Conferencing Module, and then click the
Conference Attendant Settings tab.
4 Type the extension that the system uses for IP Conferencing. This
extension must be an unused extension on the system in the range of
external extensions, which is defined as 6000-7999 by default in a 4-digit
dial plan. You must use a different extension from the one you used to
configure the IP Conference Server settings.
5 Type a description for the IP Conferencing Module.
6 Type the IP address for the IP Conferencing Module.
7 Type a port number. A SIP endpoint is identified by the IP and port
combination.
Port 5092 is the port number defined in the IP Conferencing server for
running the Conference Attendant.