Filter
Top Products
Pair The BlueParrott B200 Base With A Different Bluetooth Headset
See compatibility information page 8. Be sure the B200 headset is off the B200
base and both are turned off. See “Before Pairing” page 18.
1. Position the B200 base and your alternate headset no more than 3 feet apart.
2. Press and hold down the pairing button on the B200 base for approximately 5 to
10 seconds. The yellow light will flash, followed by the red and yellow indicator
lights flashing alternately. Release the pairing button.
3. Follow the alternate headset’s user guide for putting the headset into pairing mode.
4. When the red light on the B200 base stops flashing, pairing has been completed
(check your headset user’s manual for pairing confirmation indicators).
Pair The BlueParrott B200 Headset With A Bluetooth Cellular Phone
See compatibility information page 8. Be sure the B200 headset is out of the B200
base and both are turned off. See “Before Pairing” page 18.
1. Position the B200 headset and your phone no more than 3 feet apart.
2. Press and hold down the the multifunction button on the B200 headset for about
5-10 seconds until you hear two series of melodic tones (hold it up to your ear).
The yellow and red indicator lights on the headset will flash alternately. Release the
multifunction button.
3. Refer to your phone’s user manual for pairing instructions. The phone’s pass code
must be set to 0000.
4. When the red indicator light on the B200 headset stops flashing, pairing has been
completed (check phone’s user manual for pairing confirmation indicators).
19