Filter
Top Products
1. Put the headset on and position the microphone properly.
2. Put the headset in Talk Time mode*: Firmly press and release the multifunction
button on the headset for 1 second. You will hear a beep. The headset icon will
light up on the right side of the base indicating that the headset is in Talk Time
mode (it may take 1-5 seconds for the icon to light up). Activate your phone by
removing the handset from the cradle or by pressing the line or headset button.
If the dial tone is too loud when you activate your phone, you can press the volume
decrease button 1-3 times before activating the headset.
3. Dial as usual.
* If the headset icon is already showing on the front of the base, then the headset is
already in Talk Time mode and you may proceed to step 3.
4. To end the call, place the handset back in cradle, or press the line or headset but-
ton on the phone to end the call. To return to Standby Mode, press the multifunction
button on the headset for 1 second. The handset icon will light up on the base after
1-5 seconds and Talk Time usage will cease.
Adjust The Microphone Volume
The Microphone Volume Adjustment is located on
the bottom of the B200 base (see photo). If the per-
son on the other end of the call says your voice is
too quiet, position the base as shown and turn the
knob clockwise to increase the volume. If they say
your voice is too loud, turn the knob counterclock-
wise to decrease volume. A paper clip may be insert-
ed in the slot of the knob to assist in the turning.
15