Filter
Top Products
16
Answer A Call / End A Call
Before answering, make sure the headset is on (page 14)
1. Put the headset on and position the microphone properly.
2. Put the headset in Talk Time mode* by pressing the multifunction button on the headset
for 1 second, then release. Within 1-5 seconds, the headset icon will light up on the
right front side of the base.
* If the headset icon is already showing on the front of the base, then the headset is
already in Talk Time mode and you may proceed to step 3.
3. Remove handset from cradle or press the line or headset button. You will be con-
nected to the call.
4. To end the call, place the phone’s handset back in the cradle or press the phone’s
line or headset button to disconnect the call on your phone. To return to Standby
Mode, press the multifunction button on the headset for 1 second. The handset icon
will light up on the base within 1-5 seconds and Talk Time usage will cease.
Adjust Speaker Volume
To adjust the volume in your earpiece, press the increase or decrease volume button
for 1 second, then release. Repeat until volume is at desired level. You will hear a sin-
gle beep each time you press the button.
Mute The Microphone On The Headset
To mute the microphone, press and hold down the Increase Volume button for 4 sec-
onds. You will hear a beep and the microphone will mute. A beep will be heard period-
ically indicating that the microphone is in Mute Mode. This will not be heard on the
other end of the call.
Un-Mute The Microphone On The Headset
To un-mute the microphone, press and hold down the Increase Volume button for 4
seconds. You will hear a beep and the microphone will un-mute.