Filter
Top Products
Appendix
65
No battery
No battery is installed. Follow the directions for battery
installation on page 3 to install the battery before charging.
No line
There is no telephone line connected.
No signal,
call ended
Communication between the handset and telephone base
is lost during a call.
Not available at
this time
One handset is already viewing the caller ID log or
directory, and another handset attempts to review it.
You attempt to place a PTT call to another handset which
is on an outside call or intercom call, or accessing the
answering system.
Number already saved
The telephone number entered is already stored in the
directory.
Out of range OR
No pwr at base
The handset cannot communicate with the telephone base.
Check the telephone base power connection or move closer.
** Paging **
The system handset is being paged.
Phone
The handset is on a call.
Place in charger
The battery is very low. Place the handset in the
telephone base or charger for recharging.
Rec mem full
The answering system memory is full.
Rec mem low
The answering system has less than three minutes of
recording time left.
Ringer muted
The ringer is muted temporarily during an incoming call or
intercom call.
Ringer off
The ringer is turned off.
Saved
Your selection has been saved.
Speaker
The handset speakerphone is in use.
Unable to call.
Line in use
You try to predial a number while the telephone line is in use.
Unable to call.
Try again.
You try to join a call when there are already four handsets
on that call, or to make an outside call when another
handset is transferring a call with the intercom feature.
Unable to save
You try to save a caller ID entry without a number into the
directory.
XX Missed calls
There are XX calls that have not been reviewed in your
caller ID log.
XX New messages
There are XX new messages in the answering system.
Handset display screen messages