Filter
Top Products
6
Getting started
Headset charger installation
Install the headset charger as shown below.
Headset charger
Plug the small end of
the headset charger
power adapter into
the power jack of the
headset charger.
Plug the large end of the
headset charger power
adapter into an electrical
outlet not controlled by a
wall switch.
Power on the headset
Power on the headset before use. Place the headset in the headset charger
or press and hold for two seconds. The light ashes three times in blue
and you hear three beeps when the headset is being powered on.
Headset charging
After installing the headset charger, charge the headset as shown below.
The headset is fully charged after three hours of continuous charging. If the
light does not turn on while charging, you need to charge the headset
without interruption for at least 15 minutes to give the headset enough
charge to use for a short time. For best performance, keep the headset in
the headset charger when not in use. See the table on page 104 for battery
operating times.
1. Place the tip of
the headset in the
small cradle on
the headset charger.
2. The magnet holds
the top of the
headset in place.
The light turns
on when charging.
If the headset will not be used for a long time, press and hold for two
seconds to power off the headset. The light ashes three times in red and
you hear three beeps when the headset is being powered off.
The headset battery is not replaceable.