Filter
Top Products
20
Copyright 2008 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
1. To launch the Scanner Settings, tap Start
→ Settings → Control Panel → double-
tap Scanner.
2. The Scanner Control Panel opens.
In the Scanner Control Panel screen, it is possible to configure bar code scan-
ner parameters such as enabling or disabling bar code symbologies, set data
transmission options, configure magnetic and proximity reading options and set
power management options.
3. To test the bar code scanner, tap the Test
tab.
4. Tap Tools → Enable Scan.
5. To perform an auto-scan, tap Tools → Auto
Scan → Start Auto-Scan.
6. Input an interval. The default value is three
seconds. Tap Start. The laser scans every
three seconds and the bar code automati-
cally scans.
7. To stop the auto-scan, tap Tools → Auto-
Scan → Stop Auto-Scan.