Troubleshooting
If your XC610
Series/XC710
Cordless Telephone is
not performing to your expectations, please try these
simple steps. If you are still unable to resolve the
problems, contact Uniden Customer Service for
assistance.
Problem
Suggestion
Chanrge
light won’t come
l Make sure AC
on
when Handset is Adapter is plugged
placed
in Base Unit.
into the Base Unit
and wall outlet.
l Make sure Handset is
properly seated in
Base Unit.
l Make sure that the
charging contacts on
the Handset and
Base Unit are clean.
Audio
sounds weak
and/or scratchy.
l Make sure that the
Base Unit antenna is
fully extended and
vertical.
l Move the Handset
and/or Base Unit to
different locations
and try again.
l Press the
@
button to select
another channel.
Can’t make or receive
calls.
l Check both ends of
the Base Unit
telephone line cord.
l Make sure the AC
Adapter is plugged
into the Base Unit
and wall outlet.
l Disconnect the AC
Adapter for a few
minutes, and then
reconnect it.
Problem
Suggestion
Handset doesn’t ring or
l Nickel-Cadmium
receive a page.
battery pack may be
weak. Charge the
battery on the Base
Unit for
15-20
hours.
l Extend the Base Unit
antenna vertically.
l The Handset may be
too far away from the
Base Unit.
l Place the Base Unit
away from noise
sources.
l The Digital Security
Code may be erased.
Set the Digital Code.
Hear only continuous l The power has been
static from Handset and interrupted during a
phone will not turn off.
call.
l Restore power to the
Base Unit.
l If a power failure has
occurred and power
will be out for some
time, remove the
battery from the
Handset. This will
prevent the battery
from completely
discharging.
34
35