Uniden XC610 Series Cordless Telephone User Manual


 
4.
When the beeping
stops, briefly remove
the Handset again,
and then return it to
the Base Unit.
Mote: The CHARGE
LED will blink to
indicate that the Digital
Security Code is set to
one of the more than
65,000 codes.
If the Base Unit loses power while the Handset is off
the Base, the Digital Code may be erased. When
this happens, the Handset will not function. To
reestablish communication between the Handset
and
1.
2.
Base Unit:
Restore power to the
Base Unit.
Place the Handset
back on the Base Unit.
3. The CHARGE LED will
blink to indicate that
the Digital Security
Code is set.
Using Your Phone
Making and Receiving Calls
The following features of the XC610
Series/XC710
phone is different depending on the Handset’s
location when you make or receive a call.
I
HANDSET ON
BASE
ANSWER
I
Pick up Handset
CALL
(AutoTalk)
1
1)
Pick up
Handset
MAKE
Call
2) Press
@
3) Listen for dial
tone
4) Dial the
number
Press
@
HANDSET OFF
BASE
Press
@
1) Press
@
2)
;;;n
for dial
3) Dial the
number
HANG UP
-OR-
Return Handset to Base
(AutoStandby)
the phone, you may get an error tone and the
phone will not disconnect.
If
this happens,
place the Handset on the Base Unit or press
@
again while holding the Handset close to
the Base Unit.
1
1)
Pickup
Handset
REDIAL
2) Press
@
3) Listen for dial
tone
4) Press
@I
1) Press
@
2) Listen for dial
3)
KZ.s
@j?
Note: Sometimes when you press
@
to hang up
24
25