Filter
Top Products
Continuous Battery Charging
For the best battery performance, return the Handset
to the Base Unit at the end of the day. This keeps
the battery fully charged, so your phone works best.
Low Battery Indicator
When the Battery Pack in
the Handset is very low
and needs to be charged,
the
TALK/BATT
LOW LED
flashes.
If the
TALK/BATT
LOW LED begins to flash, the
phone is programmed to eliminate its functions to
save power. The table below describes what to do to
return your phone to normal operation.
During a Call
In Standby Mode
Only the
@
button
None of the buttons will
operates.
operate.
The Handset beeps The Handset
and the
TALK/BATT TALK/BATT
LOW LED
LOW LED flashes once
every 3 seconds.
flashes once every 3
seconds.
Complete your call as
You will not be able to
quickly as possible.
make a call.
Return the Handset to
Return the Handset to
the Base Unit for the Base Unit for
charging. charging.
Note: Allow 15 to 20 hours without any interruption
for the Handset to
fully
recharge.
Setting the Pulse/Tone Switch*
Be sure the PULSE/TONE switch is in the TONE
position.
Note: Most phone systems are Tone
dialing.
Check
with your local phone company if you are not
sure whether your system is Tone or Pulse
dialing.
l The New Zealand model is a tone only telephone
and the
Pulse/Tone
switch has been disabled.
Adjusting Ringer Controls
To adjust the ringer volume
of your Handset, press
@
when the phone is not in
use.
Handset Ringer Volume
Control
20
21