Filter
Top Products
2. Enter the number to be dialed in Pulse Mode.
3. Press the If button on the Handset. (Note:The If button counts as one
digit.)
4. Enter the number to be dialed in Tone Mode.
5. If you wish to enter a delay between numbers (for accessing a
switchboard, or long distance service), press RDLJPat the point in the
number sequence you wish to pause. (Note: The RDLJPbutton counts as
one digit.) Pressing RDLJPmore than once will increase the length of the
pause between numbers.
6. Press MEMand a number (01-20) for the memory location you wish to
use.
You will hear a beep when the stored number has been successfully
entered.
Dialing a Stored Number
To dial a number previously stored in memory, press TALK,then press MEM
and the memory number (01-20). Your XC 310 will then dial the previously
stored number.
Chain Dialing
On certain occasions, after dialing a number, you may be requested by the
party or service you are calling to enter a special access code, such as when
performing a banking transaction. You can do this conveniently by first
storing the access code into one of the memory numbers. Then, after dialing
the main number, press MEMand the memory number of the access code at
the appropriate time.
Erasing a Stored Number
1. Remove the Handset from the Base Unit. Do not press TALK.
2. Press MEMtwice.
3. Press the memory location number you want to clear.
You will hear a long beep confirming that you have erased the number.
18