Filter
Top Products
Using the AutoStandby Feature
When you finish a call and place the Handset back on the Base Unit,
AutoStandbyautomatically hangs up the phone. There is no need to press
TALKto hang up.
NOTE: If you don't place the Handset back on the Base Unit, you need
to press TALKto hang up the phone.
NOTE: Sometimes whenyou press TALKto hang up the phone, you may
get an error tone and the phone will not disconnect. This may
occur during conversations under noisy conditions. If this
happens, place the Handset back on the Base Unit, or press
TALKagain while holding the Handset close to the Base Unit
Storing a Number
To store a number in memory:
1. Removethe Handset and press MEM.(Do not press TALK.)You will hear
a beep indicating the unit is ready to be programmed.
2. Enter the number (up to 16 digits) you want to store.
3. If you wish to enter a delay between numbers (for accessing a
switchboard,or longdistanceservice),pressROUPat the point in the
number sequence you wish to pause. (Note: The ROUPbutton counts as
one digit) Pressing ROUPmorethan once will increase the length of the
pause between numbers.
4. Press MEMand a number (01-20) for the memory location you wish to
use.
You will hear a long beep when the number you have entered has been
successfully stored.
NOTE: Youhave 20 seconds after pressing MEMto enter the number you
wish to store. Otherwise, an error tone will sound.
5. Write the stored number and its memory location number on one of the
enclosed stickers so you won't forget them.
Storing a Mixed Tone/Pulse Number Witha Pulse Dial
System (available on Australian Models only)
If you've set up your XC 310 for Pulse Dialing, you can store a mixed mode
number to make it easy to access long distance services. To store a mixed
mode number (up to 16 digits):
1. Press MEM.(Do not press TALK.)You will hear a beep indicating the unit
is ready to be programmed.
17