Filter
Top Products
17
Installing the Belt Clip
Line up the holes on each side of the handset. To attach the belt clip, insert into the holes on
each side of the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the tabs from the holes.
Connecting to the Phone Line
Once the handset battery pack is fully charged, connect the
telephone line cord to the TEL LINE 1/2 jack and to a tele
-
phone outlet.
For 2 line subscriptions,
If the two phone lines are in one modular jack, connect
using TEL LINE 1/2 jack.
If the two phone lines are on two separate modular
jacks, connect using both TEL LINE 1/2 and TEL LINE
2 jacks.
Testing the connection
To test your connection, try making a call. If your call connects, the settings are ne. If your call does not connect,
check the following:
Check the AC adapter cord. Make sure it is securely connected to the DC IN connector and to a standard AC
power outlet.
Check to make sure the battery is fully charged. (If you don’t see the “battery full” icon, check to make sure
the battery is properly connected.)
Change dial mode (instructions on page 1
8).
1)
2)
•
•
1)
2)
3)