Filter
Top Products
[ 11 ]
GETTING STARTED
Mounting the base unit on a wall
Setting the handset retainer clip for wall mounting
1)On the base unit, pull the handset retainer out of
the slot. Rotate it clockwise 180 degrees.
2)Flip the retainer from front to back. Slide it back
into the slot so that the lip of the retainer is up
and the oval is down. The retainer holds the
handset in place.
Standard wall plate mounting
This phone can be mounted on any standard telephone wall plate.
1)Snap the wall mount adapter into the notches
on the base.
2)Plug the AC adapter to the DC IN 9V jack.
Route the AC adapter cord inside the molded
wiring channel as shown.
3)Plug the AC adapter into a standard 120V AC
wall outlet.
4)Plug the telephone line cord into the TEL LINE
jack. Route the cord inside the molded wiring channel
as shown.
5)Plug the telephone line cord into the telephone outlet.
6)Raise the antenna to a vertical position.
7)Align the mounting slots on the base with the
mounting posts on the wall. Push in and down until
the phone is firmly seated.
DO NOT use an outlet
controlled by a wall
switch.
GETTING STARTED
TRU546 ENG 7/25/01 1:20 PM Page 11