Filter
Top Products
[ 10 ]
• After installing the battery pack in the handset, charge your handset at
least 15-20 hours before plugging into the phone line. Once the
handset battery pack is fully charged, connect the telephone line cord to
the base and telephone wall outlet.
5)Connect the telephone line cord to the
TEL LINE jack and to a telephone outlet
once the handset is fully charged.
If your telephone outlet isn’t
modular, contact your telephone
company for assistance.
D. Choose the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the
phone lines. However some phone systems still use pulse dialing such as in
rural areas. The default setting is tone dialing. Depending on your dialing
system, set the mode as follows:
• If you are not sure of your dialing system, set for tone dialing. Make a
trial call. If the call connects, leave the setting as is, otherwise set for
pulse dialing.
• If your phone system requires pulse dialing and you need to send the DTMF
tones for certain situations during a call, you may “switch-over” to tone
dialing. (Refer to “Tone Dialing Switch-over” on page 19.)
Modular
If your dialing system is Set the switch to
Tone TONE
Pulse PULSE
GETTING STARTED
TRU546 ENG 7/25/01 1:20 PM Page 10