Filter
Top Products
GETTING STARTED
GETTING STARTED [ 9]
C. Connect the base unit
1)Connect the AC adapter to the
DC IN 9V jack and to a standard
120V AC wall outlet.
2)Set the base on a desk or tabletop,
and place the handset on the base
unit as shown. Remove the beltclip,
if attached, for face up charging.
(See “Mounting the Base Unit on a
Wall”, on page 11.)
3)Then raise the antenna to a vertical position.
4)Make sure that the status LED lights. If the LED
does not light, check to see that the AC adapter
is plugged in and that the handset makes good
contact with the base charging contacts.
•Use only the supplied AD-312 AC adapter. Do not use
any other AC adapter.
•Connect the AC adapter to a continuous power supply.
•Place the base unit close to the AC outlet so that you
can unplug the AC adapter easily.
• The handset can be
placed up or face
down in the base for
charging.
• You have to remove
the beltclip, if
attached for face up
charging.
Place the power cord so
that it does not create a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
TRU546 ENG 7/25/01 1:20 PM Page 9